Saturday 30 April 2016

Yamaha YBR 125 motorcycle battery maintenance






If in doubt just replace the battery , you can buy them quite cheap



 









First i like to test the battery on the bike .


Test at the battery posts and at the battery Positive and negative wire

terminals to ensure you have good voltage at both and to ensure

clean terminals . then test again with engine running .

You should over 12v and them close to 14v at 6000 revs .


Yamaha YBR 125 motorcycle battery maintenance





Battery , make sure its fully charged remove from bike and recharge

 do not just guess and whilst doing this clean up the battery terminals

 and the negative and positive wiring terminals .

If you have a voltage meter you can do some basic tests
.
When the engine has been off for at least 1-2 hours with ignition key

turned off,
100% Charged 12.60 to 12.8v

75% Charged 12.4v

50% Charged 12.1v

25% Charged 11.9v

0% Charged less than 11.8v







I always clean the terminals of a battery on routine Maintenance too

and i always test ground wires for continuity but its best to test earths

with a 4 amp test light to ensure adequate current flow .


sorry for photo best i could find but you get the idea test your

grounds for minimum 4 amp current flow .

Yamaha YBR 125 motorcycle battery maintenance





I remove battery and clean the outside , baking power is

recommended to neutralise the acid and any spilled acid under the

battery to stop corrosion .


Yamaha YBR 125 motorcycle battery maintenance

Yamaha YBR 125 motorcycle battery maintenance


Now test battery and top up electrolyte level 


Yamaha YBR 125 motorcycle battery maintenance

remove all the top caps for each cell 

Yamaha YBR 125 motorcycle battery maintenance

and check the level indicator on the front of the battery 
all mine were low so had to top them all up .


Yamaha YBR 125 motorcycle battery maintenance


Yamaha YBR 125 motorcycle battery maintenance

Use only Deionized water - as the level falls the acid becomes more
powerful so you are adding water to dilute the acid to its correct strength 

so do not add acid .




I would now charge the battery to full capacity i am not going to as i do not have time during this post but will later .

After charging or before you can test each individual cell to see if you have a faulty cell 



test between positive and first closest cell 

Yamaha YBR 125 motorcycle battery maintenance

and then between cells 

Yamaha YBR 125 motorcycle battery maintenance

Yamaha YBR 125 motorcycle battery maintenance

Yamaha YBR 125 motorcycle battery maintenance

Yamaha YBR 125 motorcycle battery maintenance

You are looking for around 2v per cell to indicate excellent battery

 , id ignore my results as one its not an excellent battery to i just

 topped up the water levels and there it was totally

flat but you get the idea .



---------------------------------------------------------------------------



Last thing to check is a load test connect the battery back into the

 bike and whist turning the bike over so on heavy electrical load test

 the voltage at the battery if you read less than 11v you have duff

 battery 11v and over indicates a good useable battery .







No comments:

Post a Comment